Macpower Alumni Manuel d'instructions télécharger pdf (Page 10)

SVAT ELECTRONICS

now you can see

CLEARVU11

BASIC SETUP

MOUNTING THE CAMERA

1. Screw the mounting bracket into the camera’s mounting hole,

turning it clockwise.

2. Mount the camera in the desired location no more than 60 feet from

the DVR unless you have purchased additional wiring. You may wall

mount or desk mount these cameras.

3. Adjust cameras to the desired viewing angles.

1. Plug the 4PIN DIN female connection

on the camera into the 4PIN DIN male

connection on the 60ft video/power wire.

2. Plug the camera’s power supply into one of

the 4 ports of the power supply.

3. Plug the four port power supply into the

12 V adapter.

4. Plug the power supply into the 12 V

adapter.

5. Attach all of the BNC to RCA adapters

to the camera inputs and the monitor

outputs on the back of the LCD/DVR.

6. Connect the male RCA plug from the 60

ft power wire to the BNC connectors on

the channel inputs (1-4) on the back of

the DVR.

7. Plug the other end into the female end

of the 3.5 mm wire from the camera.

Follow these instructions for the installation of each camera. The 60ft video/power wire has two connections: one for

video out, and one for power.

WIRING THE CAMERAS

1 2

6 7

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 73 74

Pas de commentaire

Macpower Alumni Manuel d'instructions Page 10